肠靶向海藻酸钙基微胶囊的制备及控释性能研究

利用毛细管共挤出技术结合静电吸附和仿生硅化的方法，制备了海藻酸钙-壳聚糖/精蛋白/二氧化硅(ACPSi)复合微胶囊。ACPSi复合微胶囊的平均粒径约3.18 mm，单分散性好，囊壁最外层的二氧化硅层可抑制其在肠液pH环境中的溶胀，增强囊的机械稳定性。将羟丙甲基纤维素邻苯二甲酸酯(HPMCP)肠溶微球作为释药“微阀门”，嵌入囊壁可以更好地控制微胶囊的释药行为。以吲哚美辛为模型药物，当药物浓度为22.5 mg/ml时，ACPSi载药微胶囊在pH 2.5模拟胃液中3 h时累计释药率仅为0.33%，而转移至pH 6.8模拟肠液中19 h时累计释药率为77.78%；囊壁嵌入HPMCP微球后，22 h时累计释药率可提高约4%。因此，该复合微胶囊具有良好的肠靶向作用和控释特性，作为口服肠靶向缓控释制剂具有良好的应用前景。     

基于射流冲击作用的舰机适配性数值分析与优化

准确分析和控制射流冲击对航母甲板环境的影响是新型喷气偏流板设计和布局的关键所在。为了确定射流冲击影响最小的偏流板布局，运用有限体积法，采用分区混合网格方案，结合雷诺时均纳维斯托克斯（RANS）方程和SST k-ω湍流模型对喷气偏流板在不同布局下的射流冲击效应进行三维数值模拟。选取舰载机双发动机全加力状态时喷气偏流板与发动机距离不同、喷气偏流板倾角不同共12种布局组合进行射流冲击效应的对比计算,计算结果显示了喷气偏流板各布局下的流场参数、传热特性、尾喷口温升、冲击力和力矩等分布规律。定性和定量分析了燃气射流冲击下温度场和速度场的危险区域，结果表明，偏流板与发动机距离5 m、偏流板倾角45°时的布局更有利于将燃气射流向上引导。在此基础上，基于倾角最小化原则及二次导流原理优化设计了一种导流隔热性能好、工作稳定性高的被动隔热式喷气偏流板装置。     

苏通GIL运输专用机具动力电池类型探讨

GIL运输专用机具是为安全、可靠、高效地完成苏通GIL综合管廊工程GIL单元的运输任务而研制的专用机具,其中动力电池系统设计是整机设计的重点之一。通过对各种常见动力电池优缺点的分析,并结合苏通GIL运输专用机具对动力电池的需求分析,确定了动力电池系统的技术路线,为苏通GIL运输专用机具的研制提供了坚实的基础。     

EGD级环保型润滑油及其生物降解性

 经生物降解性评定和粘度测量确定了EGD级生物降解二冲程润滑油复合基础油的组成；通过发动机清净性试验确定了添加剂组成配方和总添加量。在此基础上，研制了生物降解二冲程油(Oil B)，其达到了ISO EGD级二冲程油标准中规定的6个发动机性能指标和2个理化性能指标，生物降解性达到73.1%。     

基于多抽样率信号处理的无源雷达MTD方法

以数字电视信号为机会照射源的雷达系统研究为背景 ,提出用以多抽样率信号处理为基础的多级抽取信号处理算法解决运动目标检测中海量数据处理问题。文中叙述了数字电视广播信号回波的数学模型、多级抽取基本原理、目标检测算法 ,以数字电视信号为反射回波做了仿真 ,对运动目标进行检测 ,并对仿真结果做了分析。     

Prolonged tamoxifen exposure selects a breast cancer cell clone that is stable in vitro and in vivo

The effects of long-term tamoxifen exposure on cell growth and cell cycle kinetics were compared between oestrogen receptor (ER)-positive (MCF-7) and ER-negative (MDA-MB-231) cell lines. In the MCF-7 cell line, prolonged tamoxifen exposure (0.5 mumol/l for > 100 days) blocked cells in G0-G1 of the cell cycle, and slowed the doubling time of cells from 30 to 59 h. These effects corresponded to an increase in the cellular accumulation of tamoxifen over time [mean area under concentration curve (AUC) = 77.92 mumoles/10(6)/cells/day]. In contrast, in the MDA-MB-231 cell line, long-term tamoxifen exposure had no obvious effect on the doubling time, and reduced cellular tamoxifen accumulation (mean AUC = 50.50 mumoles/10(6)/cells/day) compared to the MCF-7 cells. Flow cytometric analysis of MDA-MB-231 cells demonstrated that a new tetraploid clone emerged following 56 days of tamoxifen exposure. Inoculation of the MDA-MB-231 tetraploid clone and MDA-MB-231 wildtype cells into the opposite flanks of athymic nude mice resulted in the rapid growth of tetraploid tumours. The tetraploid tumours maintained their ploidy following tamoxifen treatment for nine consecutive serial transplantations. Histological examination of the fifth transplant generation xenografts revealed that the tetraploid tumour had a 25-30 times greater mass, area of haemorrhage and necrosis, a slightly higher mitotic index and was more anaplastic than the control neoplasm. The control wildtype MDA-MB-231 tumours maintained a stable ploidy following tamoxifen treatment until the eighth and ninth transplantation, when a tetraploid population appeared, suggesting that tamoxifen treatment may select for this clone in vivo. These studies suggest that prolonged tamoxifen exposure may select for new, stable, fast growing cell clones in vitro as well as in vivo.     

Dy3+激活的几种硼酸盐在VUV-VIS范围的光谱性质

本文报道了SrAl2B2o7:Dy^3 、BaAl2B2O7:Dy^3 、SrAl3BO7:Dy^3 、La2CaB10O19:Dy^3 的紫外－真空紫外（UV－VUV）激发光谱和UV激发下的发射光谱。根据发射光谱讨论了Dy^3 离子在这几种基质中发光的黄蓝比（Y／B）。在VUV激发光谱中推测了Dy^3 的f-d跃迁及电荷迁移态（CTS）和基质吸收的位置。     

Photoluminescence and X-ray Diffraction of Distributed Bragg Reflector

Spectral and structural characteristics of distributed Bragg reflector (DBR) in vertical-cavity surface-emitting lasers were studied with photoluminescence and double- crystal X- ray diffraction measurement. The expected high quality epitaxial DBR structure was verified. In the X- ray double- crystal rocking curves of DBR the zeroth- order peak, the first and second order satellite peaks were measured. Splitting of diffraction peak appeared in the rocking curves was analyzed. The effects of introduced deep energy levels on the structural perfection and optical properties were discussed.     

引水发电系统无压隧洞中弃水堰位置的数值模拟研究

水电站引水发电系统无压隧洞中的水力过渡过程是近年来电站设计中出现的一个新课题,特别是流域梯级电站开发中经常遇到。结合工程实例应用扩散法,给出了无压隧洞水力过渡过程数值模拟的基本方程以及上下游及弃水堰等边界附加方程,模拟了弃水堰布置在不同位置下,无压隧洞内的水位变化过程。研究成果和讨论对实际工程应用具有参考意义。     

Accuracy of using computed tomography to identify pedicle screw placement in cadaveric human lumbar spine

STUDY DESIGN: Utility of using computed tomography to predict pedicle screw misplacement. OBJECTIVE: This study defines the sensitivity and specificity of predicting pedicle screw placement by experienced clinicians using a CT scan image. SUMMARY OF BACKGROUND DATA: In clinical and research settings, the method most commonly used to evaluate pedicle screws placement has been computed tomography. However, no current literature describes the accuracy of this method of evaluating screw placement. METHOD: Cobalt-chrome and titanium alloy pedicle screws of identical size were placed in six cadaveric human lumbar spine. Wide laminectomy was performed to allow complete visualization of the pedicles. Three consecutive lumbar levels were instrumented in each spine, giving 36 pedicle screw placements to identify. The instrumented spines were imaged, and four orthopaedic spine surgeons and a musculoskeletal radiologist were asked to read the images to identify the accuracy of screw placement within the pedicles. RESULTS: The sensitivity rate of identifying a misplaced screw was 67 +/- 6% for cobalt-chrome screws compared with 86 +/- 5% for titanium screws (P < 0.005). The specificity rates of radiographic diagnosis of misplaced pedicle screws were 66 +/- 10% for cobalt-chrome screws and 88 +/- 8% for titanium screws (P < 0.005). Similarly, a statistically significant difference was found in the sensitivity rates of identifying screws placed correctly in the pedicle: 70 +/- 10% for cobalt-chrome screws versus 89 +/- 8% for titanium screws (P < 0.005). Overall accuracy rates were 68 +/- 7% for cobalt chrome screws versus 87 +/- 3% for titanium screws (P < 0.002). CONCLUSION: Reliance on the computed tomography scan data alone in determining accuracy of pedicle screws can lead to inaccuracies in both clinical and research conditions.